Konfigurasi Router Menggunakan Kabel Serial

Nama : A'an Rihan

TJBL WAN

Koneksi 2 Router with Kabel Serial DCE

 

nih gan ane kasi tutorial buat ngoneksikan 2 router pada satu jaringan menggunakan paket tracer (cisco)

langkah pertama  anda memerlukan 4 pc, 2 server, 2 switch ,2 router  dan sebotol fruitea ( biar gak haus)

kemudian setting IP address dan default gateway pada PC0,PC1,PC2,PC4,server0&server1 sesuai dengan gambar diatas.

1. setting Router 0

Masuk CLI

Router >enable

Router #configure terminal

*Enter configuration commands, one per line. End with CNTL/Z.

Router(config) #interface FastEthernet0/0

Router(config-if) #ip address 10.10.10.2 255.0.0.0

Router(config-if) #no shutdown

Router(config-if) #exit

Router(config) #interface Serial2/0

Router(config-if) #no shutdown

Router(config-if) #clock rate 9600

Router(config-if) #ip address 202.132.1.1 255.255.255.0

Router(config-if) #exit

Router(config) #ip route 192.168.10.0 255.255.255.0 202.132.1.0

Router(config) #router rip

Router(config-router) #network 192.168.10.0

2. Setting Router1

Masuk CLI

Router >enable

Router "configure terminal

*Enter configuration commands, one per line. End with CNTL/Z.

Router(config) #interface FastEthernet0/0

Router(config-if) #ip address 192.168.10.2 255.255.255.0

Router(config-if) #no*shutdown

Router(config-if) #exit

Router(config) #interface Serial2/0

Router(config-if) #no shutdown

Router(config-if) #clock rate 9600

Router(config-if) #ip address 202.132.1.2 255.255.255.0

Router(config-if) #exit

Router(config) #ip route 10.10.10.0 255.255.255.0 202.132.1.0

Router(config) #router rip

Router(config-router) #network 10.10.10.0